Available with ArcGIS Pro Standard and Data Reviewer licenses.
The Evaluate Z Values check returns features with z-values that fall within specified parameters.
ArcGIS Data Reviewer checks support multiple methods for implementing automated review of data. The following table identifies the supported implementation methods for this check:
Reviewer batch job
Attribute (validation) rule
(ArcGIS Pro 2.9 and ArcGIS Enterprise 10.9.1 or later)
A z-value usually indicates the elevation of a feature in relation to the ground surface. If features from a feature class should be populated with relatively similar values for elevation, you can run the Evaluate Z Values check to ensure that the elevations are within an expected range of values. You can run the check on an entire feature class, a subtype, or a set of features selected using an SQL query. Features with z-values that fall within the specified range are returned.
The subtype to which the rule is applied.
A query that identifies the features to which the rule is applied.
The operation used to determine the threshold for z-values. Any features whose elevation values match those defined in the rule are returned as an error.
Additional input is required if you choose an operator with upper and lower bounding values.
A unique name for the rule.
This information is used to support data quality requirement traceability, automated reporting, and corrective workflows.
A description you define of the error when a noncompliant feature is found.
This information is used to provide guidance to facilitate corrective workflows.
The severity of the error assigned when a noncompliant feature is found.
This value indicates the importance of the error relative to other errors. Values range from 1 to 5, with 1 being the highest priority and 5 being the lowest.
The tag property of the rule.
This information is used in rule authoring and management workflows to support traceability and reporting of data quality requirements.
Keep the following in mind when using the check:
- A vertical coordinate system must be defined for the feature class used with this check.
- The Attribute filter parameter is limited to comparison (=, <>, >, <, >=, <=) and logical (AND/OR, IN/NOT IN, LIKE/NOT LIKE, IS NULL) operators.